Ardenghi GPE 24/2 flaming device help

Post your questions, suggestions, ideas and advice to issues you have run into in your screen printing shop.

Moderator: Moderator Team

Post Reply
Tony M
Just Browsing
Just Browsing
Posts: 2
Joined: Sat May 31, 2008 10:23 am

Ardenghi GPE 24/2 flaming device help

Post by Tony M »

I am running a GPE 24/2 and have purchased an Ardenghi made flaming device that mounts in place of the first deionization station. We have had no luck installing this device due to the complexity of these machines. Ardenghi has offered no help what so ever, other than sending the lacking instructions booklet again. Do you know of anyone in the USA that is qualified to service these machines? I would appreciate any help as we are now at a standstill. Thank you.
Post Reply