Looking for a Vector Version of these flames... I don't have allot of budget on this particular artwork need as it's personal based rather than business based...
Looking for FLAT version of these flames in VECTOR, so I can make them as large and or small as needed and so I can change colors and do effects on them..
Is someone up to the challenge? E-mail me at info@rpm-3d.com
As you will see these are from a custom decal shop... they don't have to be exactly like these flames but as close as possible... and as many flames as possible and variations as possible..
Eventually I getting a Tattoo like this.
Need Flames Created in Vector
Moderator: Moderator Team
-
- Just Browsing
- Posts: 2
- Joined: Thu May 18, 2006 9:35 am
- Location: Kansas
- Contact:
Need Flames Created in Vector
Justin Jacobs
RPM-3D "Graphics At 9,000 RPM"
http://www.rpm-3d.com
Polygon Studios
http://www.polygonstudios.com
RPM-3D "Graphics At 9,000 RPM"
http://www.rpm-3d.com
Polygon Studios
http://www.polygonstudios.com
Re: Need Flames Created in Vector
Justin,Justin Jacobs wrote:Looking for a Vector Version of these flames... I don't have allot of budget on this particular artwork need as it's personal based rather than business based...
You should check out this this post
-
- Just Browsing
- Posts: 2
- Joined: Thu May 18, 2006 9:35 am
- Location: Kansas
- Contact:
Thanks bro.. contacted them and awaiting reply..
Justin Jacobs
RPM-3D "Graphics At 9,000 RPM"
http://www.rpm-3d.com
Polygon Studios
http://www.polygonstudios.com
RPM-3D "Graphics At 9,000 RPM"
http://www.rpm-3d.com
Polygon Studios
http://www.polygonstudios.com