Burning the emulsion post design
Posted: Wed Apr 22, 2015 4:44 pm
I'm working on a labeling project with 12 size bold font.
The emulsion that I'm using is the 280 tpi with Nazdar 9624 ink and Yudu Screen machine. The problem that I have is that I can get the ink to penetrate through well enough to get on my cables.
I would like to know if after I have burned an emulsion (5 minutes) and cleaned it with water to get my design. Can I go back and burn the emulsion again and clean it off to get a clearer imprint of the design?
Thank you,
The emulsion that I'm using is the 280 tpi with Nazdar 9624 ink and Yudu Screen machine. The problem that I have is that I can get the ink to penetrate through well enough to get on my cables.
I would like to know if after I have burned an emulsion (5 minutes) and cleaned it with water to get my design. Can I go back and burn the emulsion again and clean it off to get a clearer imprint of the design?
Thank you,