Page 1 of 1
keeping the print where its suppose to be.
Posted: Tue Sep 05, 2006 3:19 pm
by Bored
i have trouble keeping the print where it is suppose to be. like the print would be a little off. i want to make it so every single one i print is identicle. are there and ways to conquer this? or any techniques?
thanks
Posted: Tue Sep 19, 2006 8:53 pm
by ROADSIDE
More information is needed
1) What are you printing? Textile or Other?
2) What equipment are you using? Manual or Auto?
3) What ink type?
4) What other info can you give?
Posted: Tue Sep 19, 2006 11:25 pm
by Bored
roadside wrote:More information is needed
1) What are you printing? Textile or Other?
2) What equipment are you using? Manual or Auto?
3) What ink type?
4) What other info can you give?
Textile
Manual press
plastisol
printing t-shirts
Posted: Wed Sep 20, 2006 9:20 am
by ROADSIDE
So whats moving the garment or the screen?
If the garment is moving on the plate then you need some spray adhesive to hold the shirt in place.
the make alot of differant sprays depending on what you requirements are.
Make sure you are using an adhesive that is made for screenprinting.
Posted: Tue Oct 03, 2006 8:38 am
by theewizard
several cause probables..
spray adhesion.. web or mist..??
if your platens are loose or balanced different on each arm..
maybe your print arms arent tightened so well.. and movement occurs during production..
fleece is bad for movement after flashing.. same as nylon dazzle.. poly dazzle usually sticks like a bitch.. ya know..
im running an 8colour manual BENMAR (brandnew) 4 bank benmar dryer..
kick ass 3k lighttable.. and a sweet space to work it all in..
st catherines Ontario.. near the border @ the falls and Buffalo\fort erie
PSIcorporate.. ktown screenprinting